Heat Activated Glue (Glue Pad Refill)

GourdMaster™ Heat Activated Designer Glue makes accenting with the Gourd Art Finishes, like metal leafing and Pigment Powders, quick and easy! (Also used as the refill for the Glue Pad). Watch this short video tutorial to learn more!

 
Scroll to the bottom of this page for links to the products featured in this video.

Written Intructions for the Heat Activated Glue:

Simply use a paintbrush to apply the glue to specific areas where you want your powders or accents, then heat the glue with your Heat Tool  (a blow dryer diffuses the heat too much and will not get hot enough!) until it is tacky and apply your Pigment Powders or Metal Leafing. A 'must' if you are applying these products to a geometric design!   See step-by-step instructions below.

Step 1: Apply small amount of GourdMaster™ heat-activated Designer Glue using a paint brush.
Step 2: Heat activate the glue using a heat tool for approx. 30 seconds or until glue has lost its shine and turned matte. (You cannot over heat the glue, so more time is better than less)
Step 3: Firmly press your metal leaf against the glue. (You can touch it with your fingers without fear of tarnishing as long as you are not using real metal leafing, such as 24k gold).
Step 4: Use a sponge brush to remove excess.
Step 5: If you went outside your lines, use a nail file or sanding stick to remove excess. You can also use your woodburning tool on low to clean your lines, or a hobby knife. For best results we strongly recommend woodburning your design before applying metal leaf.